Painted wings and giant rings

This has been a long process (mostly due to weather), and I’ve only gotten one spoon thus far, but I figured including all the pictures would be a way to show the process.

So I started out with a slightly warped Cherry turning block, which I cut in half, and then in half again horizontally, making 4 spoon sized blanks. On these I sketched the design:

From there I started to remove the wood, using some cheap gouges I had bought on amazon. It was a very slow and painful process:

So I started to look at my options, cut by band-saw, rough out using a hatchet, whittle or gouge. The rest of this page follows the gouged one. I’m going to probably start working on finishing the other three at some point in the near future as my new knives (flexcut) and gouges (Lee Valley) are significantly better.

Taking the one on the far right above, I then used my knives to finish roughing it out:

I then used the new gouges to make it pretty and thin. Today I sanded it down and used a tack cloth to remove the saw dust. I forgot how magical tack cloths are.

It still has a few nicks that became apparent when I got the saw dust off, so it’ll have to be be sanded a bit more in those spots. Also I can’t figure out how to sand the inside of the bowl.

But it is certainly spoon shaped and theoretically could be used to eat from right now! Though washing it would be a real pain with that rough wood in the bowl.