Cheese press

We’ve been using an improvised cheese press for the last year and Caitrin decided that she would be excited about cheese making if I made a real press. So I started contemplating what I wanted:

Requirements

1, Must be able to use the cheese mold we already have, and future ones we might get

2. Must be able to be sterilized

3. Must be able to handle weight increments as small as 5 pounds and as big as 50

4. Must not be able to be knocked over by my cat in the middle of the night

5. Must create even pressure so the cheese isn’t lopsided again

Our old one was so terrible I never took a picture of it, but picture in your mind a canning pot with a plate on the bottom and then the cheese mold on top of the plate, with some towels wrapped around so it didn’t slip (Which happened anyway) and then the crock pot balanced on top of the mold, filled with hand weights and held in place with large elastic bands. It functioned, but was kinda a disaster every time.

Which brings us to the new one.

I found some premium plywood in the garage that was left over from Tim’s cat tree project and cut out 2, 15″ x 15″ squares. Then I measured to the middle and made a circle showing where molds could fit – up to 1 foot in diameter (important for my cider press plans) and decided where the holes for the carriage bolts should go, two inches in on each corner:

Image

Then I drilled the holes for the 10 inch long (3/8″) carriage bolts and tried those out:

Image

That seemed to work well, so I drilled the holes on the other board, essentially creating a large flower press. On the top board I drilled three holes for the smaller 6 inch bolts that I am using to keep the Olympic style weights in place. (the Olympic style ones have three large holes, which makes them easier to use, but one could just drill one hole in the center and put one bar in for regular style weights)

Image

tightened everything down so the bolts would be flush with the wood as much as possible, and then tried it out:Image

You’ll notice in that picture I’ve noted the weight of the board on the top so I can take that into consideration when I am pressing cheese. I’ll need to buy another weight, this time only 2.5 pounds(the smallest size they make) to make it get closer to the low end of the 5 pounds of pressure.

Haven’t tried it with cheese yet, but it definitely puts pressure and holds things well under pressure. I am using a food safe plastic lid between the cheese mold and then top plate, and will use a cutting board under the press to catch the whey.

1 Comment (+add yours?)

  1. White Pearl
    Aug 11, 2013 @ 12:56:27

    lOOKS SO CREATIVE AND NICE

    Like

    Reply

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: